S&C IntelliCap 2000, Installation Manual

Page: 9 / 32

WARNING
Leave the 10-A fuse out until instructed to replace it later in the installation
process . Otherwise, dangerous unexpected bank operation may occur .
STEP 3.
Install the control on the meter base, pole, or panel, in a location with
minimum traffic exposure.
All IntelliCap 2000 controls have an internal terminal strip; the terminal strip
configuration is shown on a label inside the enclosure below the faceplate. The
terminal strip wires connect to the meter base, cable connector, or cable wire
configurations shown below. A meter base with a pole-mounting bracket and
meter-ring assembly is available from S&C.
Follow these steps to install the control on the meterbase:
STEP 1. Confirm your meter base socket is wired correctly for this control.
The required socket wiring for a four-jaw plug is shown in Figure 3. The wiring
for each type of six-jaw meter base is shown in Figures 4 through 10. The correct
configuration for the control is also indicated by a label on the back of the control
enclosure. A meter base mount control may also have sensor cable connec-
tors on the bottom of the enclosure. See Figure 11 on page 12 for connector
locations.
Meter Base Mounting
Figure 3. Four-jaw meter base socket configuration for capacitor controls with catalog number
suffix -J40. Catalog number suffix -J41 reverses only ac line and ac neutral. Catalog number
suffix -J42 reverses only open and close.
Figure 4. Six-jaw meter base socket configuration for capacitor controls with catalog number
suffix -J60.
Ac line
Open
Ac / sensor neutrals
Close
Neutral sensor
hot
Current sensor hot
Ac line
Open
Ac neutral
Close
Installing the Capacitor Control
S&C Instruction Sheet 1024-510 9