7.
Locate the remaining spokes
inside of the safe. Insert each
individual spoke into a
threaded opening and turn
clockwise to install.
Note: The SA-PLAT1-BIO model
only requires a single spoke. No
additional spokes will need
installed for that specific model.
6.
St
ep 6
WARNING: The batteries must be inserted with the correct polarity. Exhausted batteries
must be removed from the product and discarded safely. Do not mix old and new batteries.
Do not mix alkaline or standard (carbon – zinc) batteries. Do not use rechargeable (nickel –
cadmium) batteries.
6
3. INITIAL ENTRY (Continued)
Locate the 4xAA batteries.
Install them into the battery
compartment on top of the
door panel in the proper
orientation. The unit will
beep when batteries are
successfully installed.
Replace battery cover.
St
ep 7
TO REMOVE
TO ATTACH
5.
Locate the magnetic key
cover inside of your safe.
On the front of the safe,
remove the backup key
and install the magnetic
key cover in this same
location as shown.
If the backup key is
required in the future, the
magnetic key cover can
then be removed by
pressing down on the left
or right side of the
branded plate. The cover
will then pop up on the
opposite side, so it can be
removed.
St
ep 5
