San Jamar
555 Koopman Lane
Elkhorn, Wisconsin 53121
USA
T: +1.262.723.6133
F: +1.262.226.8664
[email protected]
www.sanjamar.com
Europe
Schoorstraat 26a, bus 1
2220 Heist-op-den-Berg
BELGIUM
T: +32 15 22 81 40
F: +32 15 22 81 48
[email protected]
México
Av. Paseo de la Reforma No. 350 - 10
Col. Juarez
Deleg. Cuauhtemoc, CP 06600
MEXICO, D.F.
T: +52 (55) 3626 0772
[email protected]
© Copyright San Jamar, Inc. 2018
Canada
3280 Bloor Street West
Suite 1140
11th Floor, Centre Tower
Toronto, ON M8X 2X3
CANADA
T: +1.262.723.6133
F: +1.262.226.8664
[email protected]
103391_RevA
©Copyright San Jamar 2018
Remove all three adjustment clips by lifting and pulling the clip from
the dispenser tube.
Remove the thumbnut that is
located on the underside of
the adjustment ring using a
flathead screwdriver or a dime.
Remove adjustment ring
by lifting up and over the
dispenser tube.
6a.
1a.
7a.
2a.
7a.
6b.
1b.
7b.
2b.
7b.
DISASSEMBLY CONTINUED
REASSEMBLY
Attach adjustment ring by dropping trim
ring around the dispenser tube; ensure
that the post for the thumbnut is aligned
with opening on adjustment ring.
Apply downward pressure to
attach trim ring. When properly
aligned, the trim ring will snap
into place inside the dispenser.
Tighten thumbnut with a
flathead screwdriver or a dime
to secure the adjustment ring.
Insert the pusher.
Insert both the spring and
end cap.
Align trim ring & locking tabs
with the slots on the dispenser
tube.
Insert adjustment clips by threading them into the
slots on the body of the tube. When fully inserted they
should appear as pictured.
Insert assembled dispenser back into installed mounting flange and
rotate clockwise to secure unit.
4.
5.
6.
3.