Instruction Sheet
STS-M-309-2830-12
Parallel Action Hand Tool
Rev. C
CAT-HT-309-2830-12
Date: 5/16/2014
©Samtec, Inc.
CUSTOMER S1-800-726-8329 (+1-812-944-6733)
Page 3
Adjusting the Handle Pre-Load
The tool is calibrated at the factory to the optimum pre-load required to achieve a proper crimp. It may
become necessary, over the life of the tool, to adjust the handle pre-load force.
Follow the steps below to adjust the crimping force of the hand tool to obtain proper crimp parameters
(Figure 5):
• Remove 2mm locking screw
from the adjustment wheel using
TORX head wrench.
• Using a small screwdriver, turn
the adjustment wheel to the next
marked position.
• The tool uses an eccentric axle
linkage mechanism. To increase
the handle pre-load, move the
wheel clockwise to the next
highest odd number, or
counterclockwise to the next
highest even number.
• Turn the wheel until the desired number is located over the 2mm tapped hole.
• Replace the 2mm locking screw, aligning the nearest notch in the setting wheel.
• Check the crimp against the specifications, and conduct a pull test after the tool handle pre-load force
is adjusted. Repeat the steps until the desired crimp performance is obtained.
Figure 5
