Instruction Sheet
STS-M-309-2830-12
Parallel Action Hand Tool
Rev. C
CAT-HT-309-2830-12
Date: 5/16/2014
©Samtec, Inc.
CUSTOMER S1-800-726-8329 (+1-812-944-6733)
Page 2
6. Close the handles together until the ratchet mechanism has
completed the cycle and the handles release to the fully opened
position.
7. Remove the crimped contact from the tool.
8. Manually feed the strip to locate the next terminal for crimping.
CAUTION:
Should a terminal become stuck or jammed in a partially
closed position, DO NOT use force to open or close the handles.
The tool will easily open by pushing the ratchet release lever up
(Figure 3).
Tool Maintenance
It is recommended that each operator of the tool be made aware of, and be responsible for, following
these maintenance steps:
• The tool was engineered for durability. However, for maximum service life and trouble free crimping,
establish a good process of scheduled maintenance and lubrication.
• Remove dust, moisture and other contaminants with a clean brush or soft, lint-free cloth ONLY.
• Make certain all pins, pivot points and bearing
surfaces are protected with a thin coat of high quality
machine oil. Do NOT oil excessively (Figure 4).
• Wipe excess oil from the hand tool, particularly from
the crimping area.
• It is recommended to use light oil on all pivot points
every 5000 crimps, or every 3 months.
• When tool is not in use, keep the handles closed to
prevent objects from becoming lodged in the crimping
area.
• Store the tool in a clean dry place.
Figure 3
Figure 4
