ManualsAndTutorials
www.manualsandtutorials.com
From Offical Samsung Page. All right reserved.
SAMSUNG XPRESS SL-M2022
| User Guide
In ready mode, Press and hold the (WPS) button on the button formore than ten seconds on the control panel.
You can find your machine’s PIN.
2. Press and hold the (WPS) button on the control panel for more than 4 seconds until the status LED stays on.
The machine starts connecting to the access point (or wireless router).
3. You need to enter the eight-digit PIN within two minutes on the computer that is connected to the access point (or wireless router).
The LED blinks slowly for up to two minutes until you enter the eight-digit PIN.
The WPS LED blinks in the order below:
a. The light blinks fast on the WPS LED. The machine is connecting to the access point (or wireless router).
b. When the machine is successfully connected to the wireless network, the WPS LED light stays on.
4. Insert the supplied software CD into your CD-ROM drive, and follow the instructions in the window to set up the wireless network.
Re-connecting to a network
When the wireless function is off, the machine automatically tries to re-connect to the access point (or wireless router) with the previously used wireless connection
settings and address.
In the following cases, the machine automatically re-connects to the wireless network:
The machine is turned off and on again.
The access point (or wireless router) is turned off and on again.
Canceling the connection process
To cancel the wireless network connection when the machine is connecting to the wireless network, press and release the
(
Power
) button on the control
panel.
You need to wait 2 minutes to re-connect to the wireless network.
Disconnecting from a network
To disconnect the wireless network connection, press the (WPS) button on the control panel for more than two seconds.
When the Wi-Fi network is in idle mode:
The machine is immediately disconnected from the wireless network and the WPS LED turns off.
When the Wi-Fi network is being used:
While the machine waits until the current job is finished, the light blinks fast on the WPS LED. Then, the wireless network
connection is automatically disconnected and the WPS LED turns off.
