- 28 -
5-2. ASSEMBLY AND DISASSEMBLY
Part Name
Figure
Method of Repair
MOTOR
Disassembly Order
1.Disassemble the two screws used to fix the Back
Cover.
Separate the Back Cover and remove the M19 nut used
to fix the Motor.
(Caution: Turn counterclockwise to release. Turning
slowly will make it more difficult to disassemble,
since the motor may rotate at the same time. A quick,
sharp turn is more effective.)
※ Do not stick the screwdriver into the Motor to
unscrew it. This may cause damage to the motor.
2. After removing the M19 nut, separate the Rotor by
removing the Spring Washer and the Teeth Washer
beforehand.
(A strong force is required to pull out the Rotor
due to its magnetic force. Please take care of your
hands when removing the motor, particularly with
the Stator Edge part.)
Separate the wire connected to the Motor.
(Press down on the belly of the Housing and pull
forward to separate the connector.)
3. Remove the four M10 Screws.
Remove the Assy Bracket Motor.
Remove the Stator.
(When you remove the last of the four screws, hold
the Stator with one hand to stop it from falling.)
4. Separate the Motor Wire
(Since the Hall Sensor is fragile, be careful when
handling the Hall Sensor.)
Check Toruble Points
1. Check whether there are any foreign substances
between the Rotor and the Stator.
2. Check the wire conncetions of the Motor (Blue,
White, Red).
3. Check the wire connections of the Hall Sensor
※Please Note:
- Wire connections are in the order of Blue, White,
Red.
※
Caution
Ensure that the power plug is unplugged during
repairs. There may be some danger of electric
shock.
①
②
③
④
