Samsung WF46BG65 A Series, User Manual, Page: 269 / 308

Engl
ish
English 29
STEP 4 Connect the water hose
The dryer must be connected to a cold water tap using the provided water hoses.
1. Close the cold water tap. If you have a washer’s cold
water hose attached to the cold water tap, unscrew
and remove the hose. Then, connect the female end
of the Y-connector to the cold water tap.
2. Connect the straight end of the water hose to the
Y-connector. Tighten the hose coupling by hand.
3. Using pliers, tighten the coupling an additional two-
thirds turn. Do not overtighten. You can damage the
coupling.
4. Connect the angled end of the water hose to the
filling valve at the bottom rear of the dryer. Turn the
coupling by hand until it is tight.
5. Using pliers, tighten the coupling an additional two-
thirds turn. Do not overtighten. You can damage the
coupling.
6. If you detached the cold water hose from your
washer, attach the hose to the open end of the
Y-connector, tighten the coupling by hand until it is
tight, and then, using a pliers, tighten an additional
two-thirds turn.
7. Open the cold water tap, and then check for any
leaks.
If the Y-connector cannot be directly connected to the cold water tap, use the short hose. See the “ Using
the short hose as an extension ” section on page 30 .
Untitled-6 29 2022-03-30 12:14:22