English - 10
HOW TO WASH AUTOMATICALLY DEPENDS ON THE LAUNDRY
Before starting washing, check the following;
• Connect the water supply hose to the water tap. Leave a tap open. Plug the power cord in. Make sure
to lay down the drain hose.
Washing for the fi rst time
Before washing clothes for the fi rst time, you must run a complete cycle without clothes.
To do this:
1.
Press the
Power
button.
2.
Open the detergent drawer and insert a little detergent.
3.
Turn on the water supply to the washing machine.
4.
Press the
Start/Pause
button.
This will remove any water from the manufacturer’s test run remaining in the machine.
Special notes!
Automatic Sensing Function
• According to the selected program, the amount of laundry is automatically sensed and then
the appropriate water level, wash time, rinse cycle, and spinning time are automatically
selected for the automatic wash.
• After the power is on, a program is selected and
Start/Pause
button is pressed. Then,
the washing board starts spinning without water. This action senses how much laundry is
in the washing basket, not a machine problem. After this sensing process, water supplies
automatically.
Adding Detergent and Softener
• It senses the amount of laundry and indicates the water level and amount of detergent. Then,
it starts water supply right away.
• During the water supply, it is possible to open the detergent box and add detergent.
However, it is better to press
Start/Pause
button to stop water supply and add detergent.
Close the lid and press
Start/Pause
button again. This way is much more convenient.
• If the softener is applied to the softener dispenser, it is automatically dispensed in the rinse
cycle. To dispense the fabric softener automatically, make sure you have selected all the
necessary cycles of washing, rinse, and spin.
Put the laundry into the washer and add detergent, too.
• Be careful not to overload. Use right detergent for the fabrics you are washing.
• For safety, the washing machine stops operation if the lid is open unless in water supply
mode.
(Some models display an error message if the lid is open while water is being supplied.)
• When hot water is selected, both cold and hot water are supplied for the first
20 seconds in order to protect the clothes.
• Possible to control the washing time, rinsing cycle, and spinning time at every program
during the washing.
setting up your washer
WA4000HS_DC68-03414G-07_EN.indd Sec3:10
WA4000HS_DC68-03414G-07_EN.indd Sec3:10
7/21/2020 12:48:37 PM
7/21/2020 12:48:37 PM
