ALIGNMENT AND ADJUSTMENTS
2
GENERAL ERROR FUNCTION
NO
Error Code
(Diagnostic Code
Error Image)
Description
Corrective Action
1
nd
The water level fails to drop below the
Reset Water Level within 30 minutes.
Go to “ Will Not Drain” Troubleshooting
Section.
2
LO
Door fails to Unlock After 7 attempts. Go to “ Will Not Unlock”
Troubleshooting Section.
3
nF
When the filling Continues for more
than 60 minutes or there is no change
of water level for 6 minutes.
Go to “ No Water Fill” Troubleshooting
Section.
4
FL
Door fails to lock after 7 attempts.
Go to “ Will Not Lock” Troubleshooting
Section.
5
LE
A water level lower than the Reset
water level is detected for 5 seconds
during the Wash/Rinse cycle.
Go to “No Water Fill” Troubleshooting
Section.
6
1E
Water Level Sensor Trouble. (When
the input signal from the water level
sensor is out of range, the unit will
send out beeping sounds and halts
the cycle.)
Go to “No Water Fill”
Troubleshooting Section
7
OE
A fault is detected in the water level
sensor. Data (frequency) shows the
water level is at or above the overflow
water level. (When this condition
is detected, the machine will
automatically starts draining water
until the water level falls below the
reset water level)
First check to see that all of water
valves are not stuck. If water valves
are OK, check water level.
8
dc
Unbalance or cabinet bump is
detected during final spin
Go to “Wet Clothes” Troubleshooting
Section.
9
E2
Jammed Key.(When key input signals
are coming out for more than 30
seconds, it is regarded as a jam.)
Check all of keys. If A key is sensed
to be pressed, all keys will do not
respond.
10
ds
Door is detected as open while it is
trying to lock the door.
Go to “Quick Test Mode” and then do
Door Lock/Unlock Test
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
WARNING
WA5471ABP_03051A-02(Technical information).indd 2
2012-02-13 �� 9:36:22
