8. SOAK BUTTON
• Use when a socking is needed.
• It is not allowed for the wool course.
• For the Clean Tub course, the soaking is automatically applied.
9. COURSE SELECT BUTTON
• Select the course depends on each laundry and how dirty the garments
are;
FUZZY
➔
BLANKET
➔
WOOL
➔
HEAVY
➔
SPEEDY
➔
CLEAN TUB
• Refer to the User's Manual for explanation of each course.
10. DELAY START BUTTON
• Use when you want to set up the finishing time for washing.
• If you want to cancel the reservation, power off.
11. START/HOLD BUTTON
• Use to pause and restart the operation.
• To change the washing procedure during operation, press this button to
stop, and once again to restart after changing the procedure.
12. POWER BUTTON
(Use for turning on or off the power.)
• The power goes off automatically as the wash cycle finishes.
• If the power is on for 10 minutes without selecting any other function key,
the power goes off automatically.
HOW TO WASH AUTOMATICALLY
DEPENDS ON THE LAUNDRY?
BEFORE STARTING WASHING, CHECK THE FOLLOWING
Turn on the faucet to open.
• Check if the water supply hoses are correctly
connected to cold and hot water.
Plug the power cord in.
Make sure to lay down the drain hose.
(In case no drain pump)
SPECIAL NOTES!
Automatic Sensing Function
• At every course (except, wool course) the amount of laundry is automatically
sensed and then appropriate water level, washing time, rinsing cycle, and
spinning time are automatically selected for automatic washing.
• After the power is on, a course is selected and Start/Hold button is pressed.
Then, the washing board starts spinning without water. This action senses
how much laundry is in the washing basket, not a machine problem. After
this sensing process, water supplies automatically.
Soak Wash
• Select the SOCK button.
• Add 30 minutes of soaking to the selected course.
Adding Detergent and Softener
• It senses the amount of laundry and indicates the water level and amount of
detergent. Then, it starts water supply right away.
• During the water supply, it is possible to open the detergent box and add
detergent. However, it is better to press Start/Hold button to stop water
supply and add detergent. Close the lid and press Start/Hold button again.
This way is much more convenient.
• If the softener is inserted in the softener dispenser, it automatically adds in
at the last rinsing cycle.
- 7 -
