38
_ English
SEARCHINGQUICKLYFORADESIREDSCENE(SETTINGTHEZEROMEMORY)
(VP-D382(i)/D382H/D385(i)only)
The zero memory function works in both
Camera
and
Player
modes.
➥
page 18
You can mark a point on a tape that you want to return to following playback.
1.
Set the
Select
switch to
TAPE
. (VP-D385( i ) only)
2.
Press the
MODE
button to set
Camera
(
) or
Player
(
).
3.
Press the
ZERO MEMORY
button on the remote control before the recording or
during playback at the point where you wish to return.
The time code is changed to a tape counter that is set to zero memory with
the zero memory (
0:00:00
) indicator displayed.
If you want to cancel the zero memory function, press the
ZERO MEMORY
button again.
4.
Finding the zero position.
When you have finished playback, fast forward or rewind the tape in stop mode.
The tape stops automatically when it reaches the zero position.
When you have finished recording, press the
MODE
button to set
Player
(
)
and press the
(REW)
button.
The tape stops automatically when it reaches the zero position.
5.
The tape counter with the zero memory ( ) indicator disappears from the
display and the tape counter is changed to the time code.
In the following situations, zero memory mode may be cancelled
automatically:
- At the end of the section marked with the zero memory function.
- When the tape is ejected.
- When you remove the battery pack or power supply.
The zero memory may not function correctly where there is a break between
recordings on the tape.
The zero memory function is available only using the remote control.
•
•
•
•
•
•
•
•
•
basic recording
BATT.
CHG
MODE
TAPE
CARD
16BIt
S
10Sec
C.Nite 1/30
60min
0:00:30
SP
STBY
16:9 Wide
(VP-D385( i ) only)