English - 5
English - 4
01 CHECKING THE
COMPONENTS
Surround Speaker x 2 (Left / Right) / Power Cord X 2
NOTES
•
For more information about the power supply and power
consumption, refer to the label attached to the product.
(Label: Rear of the Main Unit)
• Design and specifications are subject to change without prior
notice.
02 CONNECTING THE
SWA-9500S TO A
SOUNDBAR
1. Check the standby status after plugging into
an electrical outlet
Plug the Surround Speakers power cord into an electrical outlet
and into the Surround Speakers to turn on the Surround Speakers.
The LINK LED indicator (blue LED) on the Surround Speakers blinks.
If the LED does not blink, refer to step 6.
Bottoms of the Left and Right Surround
Speakers
Blinking blue fast
Rear of the Left and Right
Surround Speakers
2. Turn off the Soundbar
Turn off the Soundbar using the Soundbar’s remote control or by
pressing the
(Power)
button on the main Soundbar unit.
BYE
•
The image of the Soundbar may differ from your Soundbar,
depending on the model.
3.
Configure “ID SET” using the Soundbar’s
remote control
Press the
Up
button on the Soundbar remote control for 5 seconds.
•
The
ID SET
message appears on the Soundbar main unit’s display
for a short time and then disappears.
•
After the
ID SET
process, the Soundbar power is automatically
turned on.
SOUN
D
MOD
E
PAIR
5 Sec
ID SET
•
The image of the Soundbar may differ from your Soundbar,
depending on the model.
4. Check if the LINK LED is solid blue
(connection complete)
Stops blinking.
Glows blue.
Rear of the Left
and Right Surround
Speakers
The LINK LED indicator
stops blinking and glows
a solid blue when a
connection is established
between the Soundbar and
the Surround Speakers.
5. If the SWA-9500S does not connect, take
the necessary steps according to the LED
Indicator’s status
LINK (Blue) On
: Successfully connected (normal operation).
LINK (Blue) Blinking
: Recovering the connection.
•
Check if the power cable attached to the main Soundbar unit
is connected properly or wait about 5 minutes.
•
Repeat steps 2 through 4.
STANDBY (Red) On
:
Standby (with the Soundbar main unit turned off).
•
Check if the power cable attached to the main Soundbar unit
is connected properly.
Connection failed.
•
1.
Press the
ID SET
button on the back of the Surround
Speakers with a pen tip for 5~6 seconds until the LINK LED
indicator blinks (in Blue).
5 Sec
2.
Repeat steps 2 through 4.
Red and blue Blinking
: Malfunction
•
See the contact information for the Samsung Service Centre
in this manual.
Summary of Contents for SWA-9500S
Page 1: ...USER MANUAL SWA 9500S ...
