Samsung SWA-9000S/ZA, User Manual

Page: 8 / 14

ENG - 8
2. Check the standby status after plugging into an electrical outlet
Plug the Wireless Receiver Module power cord into an electrical outlet and into the Wireless
Receiver Module to turn on the Wireless Receiver Module. The LINK LED indicator (blue LED) on the
Wireless Receiver Module blinks. If the LED does not blink, refer to step 8 on page
11.
ID SET
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
POWER
STANDBY
LINK
STANDBY
LINK
Blue blinking
Attach the Toroidal Ferrite Core to the Power Cord of the Soundbar
(Applicable only when connecting the SWA-9000S and MS series Soundbars/home
theaters.)
HDMI IN
HDMI OUT
(TV-ARC)
WIRELESS
AUX IN
DIGITAL AUDIO IN
(OPTICAL)
POWER
IN
POWER
OUT
(For TV)
AC 100V~240V
4A~1.66A
POWER
IN
POWER
OUT
(For TV)
AC 100V~240V
4A~1.66A
Bottom of the Soundbar
Attach the Toroidal ferrite core to the power cord
of the Soundbar to help prevent RF interference
from radio signals.
1. Pull the fixing tab of the Toroidal ferrite core to
open it.
2. Make two loops in the Soundbar’s power cord.
3. Attach the Toroidal ferrite core to the Soundbar’s
power cord as shown in the figure on the left, and
then close it by pressing it until it clicks.
• Ensure that the ferrite core is attached as
close as possible to the power plug of the
Soundbar.