GB
14
Tuning Your Television for the VCR
You must tune your television for the VCR only if you are not using
a RCA cable
➢
To view pictures from your VCR when a RCA cable is
used, the television must be set to the audio/video mode
(AV).
1
Switch on the television.
2
Switch on the VCR by pressing STANDBY/ON on the front of the
VCR or VCR STANDBY/ON (STANDBY/ON) on the remote
control.
3
Select a programme position on the television to be reserved for
use with your VCR.
4
Insert the video cassette in the VCR. Check that the VCR starts
reading the cassette; if not, press
❿
II button.
5
Start a scan on your television or set the television to UHF
channel 36.
6
Fine tune the television until the pictures and sound are obtained
clearly.
7
If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the VCR output channel (see Solving Problems section of this
manual).
8
When the picture and sound are perfectly clear, store this channel
at the desired programme position on the television.
Result:
That programme is now reserved for use with your VCR.
★
(SV-H625K/SV-H85K)
★
(SV-H35K)
OK
REC
MENU
4
VCR STANDBY/ON
S
STANDBY/ON
S
2
2
01823T SV-H625K/AFR-GB1 3/21/03 5:04 PM Page 14
