14_
maintenance
MINI TURBO BRUSH (*select models only)
To Replace Brushroll
To Replace Belt
1. Unplug cleaner from electrical outlet.
2. Slide the switch to the unlock position and remove bottom plate.
3. Inspect condition of brushroll. Replace brushroll if brushes are
worn down. To remove brushroll, pull up and out of end slots
in nozzle housing. Insert ends of brushroll into same slots to
replace.
The Mini Turbo Brush should be checked regularly for clogs or debris wrapping around the
brush.
1. Unplug cleaner from electrical outlet.
2. Remove bottom plate by sliding switch to unlock position. See
figure in To Replace Brushroll instructions.
3. Loop one end of new belt around shaft of pulley.
4. Loop other end of belt around designated area for it on brushroll.
Insert brushroll into slots in nozzle housing. See figure in To
Replace Brushroll instructions.
5. Fit Mini Turbo Brush back together as described in To Replace
Brushroll instructions.
4. Insert the four tabs on edge of bottom plate into slots on front of
tool. Pivot bottom plate down and snap closed. Slide switch to
lock position to secure the bottom plate in place.
Inspect belt to ensure that it is in good condition. If belt is
broken or cracked, replace belt according to To Replace Belt
instructions.
maintenance
