Samsung SR8940, User Manual

Page: 118 / 196

22_ operating
Charging
When the product is initially purchased, the battery is fully
discharged, and you must charge the vacuum cleaning
robot manually.
Turn on the Power Switch at the bottom of the product.
After aligning the charge pins of the main unit with 1.
the charge pin of the charger station, press the main
unit until you hear a Recharging power sound from
the charger.
The Charging Lamp turns green.
-
Check the charge status of the vacuum cleaning robot. 2.
When charging starts, “the amount of remaining battery power” -
and “ ” are displayed on the status display panel in this
sequence.
When charging is complete, the battery level indicator and
-
“FULL” will be displayed in the display panel.
Flash Flash
Flash Flash
When the battery level display fl ashes while cleaning,
■
the vacuum cleaning robot stops vacuuming and
automatically charges itself at the charger.
If the vacuum cleaning robot starts the current cleaning
■
run at a location other than the charging station and fails
to locate the charging station while cleaning, it will stop
near the location where it started cleaning.
When the battery level fl ashes and “Lo” is displayed while
■
cleaning, vacuum cleaning robot cannot be operated by
the remote control or the buttons on the main unit. In
this case, directly carry the vacuum cleaning robot to the
charger to charge the battery. (This is when the battery is
completely discharged.)
<Charge display> <Charge display>
Charge Charge
complete
complete
Charging Charging Required Required
charging
charging
Power lamp Power lamp
Charging lamp Charging lamp
Power lamp Power lamp
Charging lamp Charging lamp
Charging Charging Fully charged Fully charged
DJ68-00664E.indb 22 DJ68-00664E.indb 22 2012.7.19 11:54:9 AM 2012.7.19 11:54:9 AM