Samsung SPHI500SS, Manual, Page: 161 / 218

Section 2: Understanding Your Phone
2Q: Advanced HotSync 158
installed infrared driver. Check your computer’s documentation to learn
if the computer supports infrared communication. If your desktop
computer uses Microsoft® Windows 98, 2000, or XP infrared
communication is built into the operating system.
To check the ports used for infrared communication:
1.
In the Windows task bar, click
Start
, choose
Settings
, and then
Control Panel
.
2.
Double-click
Infrared
.
3.
Click the
Options
tab.
4.
Select
Enable infrared communication
.
Note: The COM port displayed in the drop-down box is the port where your
infrared device is attached. It should be different from any port used by the
HotSync Manager.
5.
Make a note of which port is listed as “providing application
support.” You need this information to configure the HotSync
Manager for infrared communication.
6.
Deselect any other check boxes in the
Options
tab.
7.
Click
Apply
and
OK
to exit.
Configuring HotSync Manager for infrared communication
Next, you need to go to the HotSync Manager and specify the simulated
port used for infrared communication. To configure HotSync Manager
for infrared communication:
1.
Click the HotSync Manager icon in the Windows system tray.
2.
Make sure
Local
is checked on the menu.
3.
Select
Setup
.
4.
Click the
Local
tab.
5.
In the Serial Port drop-down box, select the COM port that was given
as the simulated port in the “Options” tab of the Infrared Monitor.
6.
Click
OK
.
Note:
The HotSync Manager is now communicating with the simulated
port defined for infrared communication. This means that you cannot use