Operating Your Camera
COLOR CCD CAMERA
User’s Manual
33
COLOR CCD CAMERA
User’s Manual
32
PRIVACY:
To mask area which you want to mask
- OFF: Deactivation
- ON: Privacy mode activated
· Press the SET button.
· Move the arrow indicator to area you want to mask.
· Set ‘ON’ using LEFT or RIGHT button.
· Press the SET button and then set the area’s bounds with the method like
MD1 Set. (see page 24)
· When completed, press the SET button.
RESET:
To reset your camera to factory default condition
END:
To move Top-menu
EXIT:
To finish setting menu
• When the power frequency is 50Hz, you can not use line-lock mode(NTSC Models).
• When the power frequency is 60Hz, you can not use the line-lock mode(PAL Models).
• ‘Sync.’ mode is fixed to ‘INT’ in DC 12V input power.
Notes
Using Remote Jack / MD Output
If you connect a remote plug to the REMOTE jack on the rear of the camera
as shown below, you can access the menu setup mode from a remote place.
1. RS-232C Communication Setting.
• Mode : Serial • Data Bit : 8 • Bit/sec : 19200bps • Stop Bit : 1
• Port : Com1 • Parity : None
2. Setup menu Command.
3. MD(MOTION DETECTION) output Signal Level (Less than 10mA)
Setup menu
Command
Byte
Set
AA, EE, 0F, CC, 55
5
Up
AA, EE, 1E, CC, 55
5
Down
AA, EE, 1D, CC, 55
5
Left
AA, EE, 1B, CC, 55
5
Right
AA, EE, 17, CC, 55
5
• You must turn the camera power off when you connect or remove the remote plug.
Notes
2.5±0.5sec
0V
+4.0V~+5.0V
There is motion
There is no motion
Summary of Contents for SOC-4120AN
Page 20: ...MEMO MEMO ...
