COLOR CCD CAMERA
COLOR CCD CAMERA
User’s Manual
User’s Manual
13
12
Name and Function of Each Part
(2) White Balance Control Mode
• ATW(Auto Tracing White balance):
The camera automatically controls the
white balance in any environment.
• AWC(Auto White balance Control):
The white balance is automatically
adjusted in a specific environment.
(3) Sharpness
The switch emphasize the sharpness. To soften the edge turn this switch off.
(4) Flickerless
Flickerless function. In this function, electronic shutter is fixed in 1/100sec
(1/120sec: PAL model). FL function can compensate the flicker caused by
power frequency, but set OFF in the area not using a 60Hz (50Hz: PAL
model) AC Power.
(5) INT/LL Switch: SOC-4020Series
Used to choose INT or LL mode.
• INT(Internal) mode :
The camera may be operated independently with its
internal crystal control.
• LL(Linelock) mode :
It synchronizes the video signal between cameras using
the frequency of the AC power supply without external synchronous generator.
(6) Not Used
• The LL mode can be used in the areas of 60Hz(NTSC models), 50Hz(PAL models).
Notes
Bottom
You can remove and install this bracket on the top of
the camera. You must use the supplied screw or the
equivalent (within 6mm). If not, the bracket may not
be fixed properly.
Tripod Mounting Hole
Used to install the camera on an optional tripod.
The tripod must be equipped with the screw
specified as shown below.
1/4"-20 UNC (20 THREAD)
L:4.5mm±0.2mm (ISO standard),
or 0.197" (ASA standard)
L
