setup screen
audio setup
You can configure the I/O settings of the audio source from the camera.
1.
From the Setup menu, select the
<
video & audio ( )
> tab.
2.
Click <
audio setup
>.
3.
Set the audio input value.
•
Source : Sets the audio input.
- Line : Connect the cable to the
audio device.
- Internal microphone : Microphone
that is built-in in the camera.
(It is applicable only to the SNB-7004/SND-7084 model.)
- External microphone : 3.5 pi(¢) jack type external MIC.
•
Apply power to Ext. Mic. : If the external microphone connected has no separate
power supply, check this option to set camera to supply power to the connected
external microphone. The option is enabled if <
external microphone
> is
selected.
•
Codec : Specify the audio codec.
- G.711 : A audio codec standard, it uses 64 Kbps PCM (Pulse Code Modulation)
encoding.
ITU standard audio codec that is adequate for digital voice transfer in PSTN
network or through a PBX.
- G.726 : ITU standard audio codec applying ADPCM (Adaptive Differential Pulse
Code Modulation) for variable bit rates of 40/32/24/16 Kbps to 64 Kbps PCM
encoding.
•
Bitrate : Set the bit rate to differentiate compression ratio if using G.726 codec.
•
Gain : Specify the audio input amplification.
J
`
Sound quality deterioration or howling may occur if the loudness of the sound source or gain value
were set excessively.
4.
Set the audio output level.
•
Enable : Sets whether to use audio output.
•
Gain : Specify the audio output amplification.
5.
When done, click [
apply (
)
].
90_
setup screen
Summary of Contents for SNB-7004
Page 1: ...NETWORK CAMERA User Manual SNB 7004 SND 7084 SNV 7084 ...
Page 19: ...English _19 overview Components c b g d e f a AU DI O IN AU DI O OU T ij k h ...
Page 157: ...SND 7084 Unit mm inch 118 4 65 Ø 132 1 5 2 Ø 97 3 82 107 6 4 24 English _157 appendix ...
Page 158: ...appendix SNV 7084 Unit mm inch 69 5 2 74 118 5 4 67 Ø 160 6 3 Ø 100 3 94 158_ appendix ...
