Samsung SMH1816B, Installation Instructions Manual

Page: 16 / 40

16
Step-by-step installation guide
17
Step-by-step installation guide
To use toggle bolts:
Wall
Toggle Wings
Toggle
Bolt
Bolt End
Spacing for Toggles More
Than Wall Thickness
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Bolt End
Mounting
Plate
Toggle
Bolt
Wall
Toggle Wings
3 . Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE : Before tightening the toggle bolts and wood
screw, make sure the bottom of the Mounting plate
runs along the bottom Horizontal line of the “Rear wall
Template” and the Mounting plate is properly centered
under the cabinet.
CAUTION : Be careful to avoid pinching your fingers
between the back of the mounting plate and the wall.
4 . Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts. Tighten the screw.
C. USE THE TOP CABINET
TEmPLATE TO PREPARE
THE TOP CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION : Wear safety goggles when drilling holes in
the cabinet bottom.
D. mOUNT THE mICROWAVE
OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
ImPORTANT: Do not grip or use handle during
installation.
NOTE : If your cabinet is metal, use the nylon
grommet in the power cord hole to prevent the cord
from being cut.
NOTE : Filler blocks are required when mounting this
unit under any cabinet with a recessed bottom or
front overhang. (See page 9.)
ImPORTANT: The case damage that will occur
from over tightening screws if you do not use
filler blocks is not covered under warranty.
NOTE : When mounting the microwave oven, thread
the power cord through hole in the bottom of top
cabinet. Keep it tight throughout Steps 1–3. Do not
pinch the cord or lift the oven by pulling cord.
1 . Lift the microwave, tilt
it forward, and hook
the slots at the back
bottom edge onto the
four lower tabs of the
mounting plate.
2
. Rotate the front of
the oven up against
the cabinet bottom.
3 . Insert a self-aligning screw through the top
center cabinet hole. Temporarily secure the oven
by turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.) B e sure to keep the power
cord tight. Be careful not to pinch the cord,
especially when mounting flush to the
bottom of cabinet.
4 . Attach the microwave oven to the top cabinet.
5 . Insert the 2 self-aligning screws through the
cabinet bottom shelf and filler block into the
outer top cabinet of the unit. Continue to support
the unit until both screws are inserted and
engaged at least two full turns, then fully tighten
both screws until the unit is secure.
6 . Install the grease filters. See the Owner’s Manual
packed with the microwave for instructions.
SMH1816_XAC_DE68-03943B-01_EN_120725.indd 16 2012-07-25 �� 7:50:52