IMPORTANT SAFETY INSTRUCTIONS
15. Apparatus shall not be exposed to dripping or splashing and
no objects filled with liquids, such as vases, shall be placed on
the apparatus.
16. POWER SOURCES:
The CAMCORDER should be operated only from the type of power
source indicated on the label. If you are not sure of the type of
power supply at your home, consult your appliance dealer or local
power company. A CAMCORDER is intended to be operated from
battery power, or other sources, refer to the operating instructions.
17. GROUNDING OR POLARIZATION:
This CAMCORDER may be equipped with either a polarized 2-wire
AC line plug (a plug having one blade wider than the other) or a
3-wire grounding type plug, a plug having a third (grounding) pin. If
you are unable to insert the plug fully into the outlet, try reversing
the plug. If the plug still fails to fit, contact your electrician to replace
your outlet. Do not defeat the safety purpose of the polarized plug.
18. POWER-CORD PROTECTION:
Power-supply cords should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them,
paying particular attention to cords or plugs, convenient receptacles,
and the point where they exit from the unit.
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
NEC NATIONAL ELECTRICAL CODE
ELECTRIC
SERVICE
EQUIPMENT
GROUND
CLAMP
ANTENNA
LEAD IN
WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
19. OUTDOOR ANTENNA GROUNDING:
If an outside antenna or cable system is connected to the
CAMCORDER, be sure the antenna or cable system is grounded to
provide some protection against voltage surges and built-up static
charges, Section 810 of the National Electrical Code, ANSI/NFPA
No. 70-1984, provides information with respect to proper grounding
of the mast and supporting structure, grounding of the lead-in wire
and supporting structure, grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna discharge unit,
size of grounding to conductors, location of antenna-discharge unit,
connection to grounding electrodes and requirements for the groun-
ding electrode.
See figure below.
20. LIGHTNING:
For added protection of this CAMCORDER during a lightning storm
or when it is left unattended and unused for long periods of time,
unplug it from the wall outlet and disconnect the antenna or cable
system.
This will prevent damage to the CAMCORDER due to lightning and
power-line surges.
ENGLISH
ENGLISH
사본 - US_Safety.indd 2
2007-01-24 오후 2:15:46
