Samsung SDE-500X, User Manual

Page: 72 / 152

72_ main menu
main menu
Setting the Motion Detection Area

Select < Motion Region >.

When “ Motion Region ” window appears, select a
channel for detection and set the area of motion
detection.
•
To set the area in “ Motion Region ” window
In the “ Motion Region ” window, select desired region
from < >.
•
To set the area using < Individual > selection
In the “ Motion Region ” window, you can select cells
individually by using < Individual >.
Motion Region
OK Cancel
Apply to All CH
CH1
Individual
When selected < Individual >, “ Motion Region ” window disappears and you can select cells one by one.
When the motion area setup is done, press the < Menu > on the screen or the [ MENU ] button on the
remote control or front panel to display the “ Motion Region ” window again.
- Select : Selected cell is set to be a part of motion detection area.
- Unselect : Selected cell is removed from the motion detection area.
- Inverse : Unselected cells are set to be the motion detection area.
- Menu : After selecting individual motion areas, move to the “ Motion Region ” window.

If selected < Apply to All CH >, selected motion area is applied to all channels.

When the motion detection setup is done, press < OK >.
Select
Unselect
Inverse
Menu
Video Loss Detection
You can set the alarm to be generated on a camera disconnection, which causes a video loss.
Using the mouse may help make setup easier.
1. Use the up/down buttons ( ) in < Event > window to
move to < Video Loss Detection >, and press [ ENTER ]
button.
A window of video loss detection area setup appears.
2. Use direction buttons (
◄ ►
) to move to a desired
item, and set the value.
•
Video Loss State : Sets whether to activate video loss
detection.
•
Alarm : Sets the alarm output method.

For further information on alarm output, refer to “ HDD Alarm >
Alarm ”. (Page 63)
•
Alarm Duration : Sets the duration of alarm signal and alarm sound.
•
Help : Displays a help message that will appear if a video loss event occurs.
3. When the video loss detection setup is done, press < OK >.
Video Loss Detection
OK Cancel
Previous/Next Page
CH Video Loss State

Alarm

Alarm Duration

1 OFF

None 10 sec

2 OFF

None 10 sec

3 OFF

None 10 sec

4 OFF

None 10 sec

5 OFF

None 10 sec

6 OFF

None 10 sec

7 OFF

None 10 sec

8 OFF

None 10 sec

Help
Help
OK
If a video loss event occurs during the event
recording, the POST recording settings of the
applicable channel will be reset.