COLOR CCD CAMERA
COLOR CCD CAMERA
User’s Manual
User’s Manual
11
10
❼
❽
❿
⓫
❾
*High Voltage Type(SDC-415PH)
❼
Video output terminal:
Sends video signal and connects to the video input terminal of the monitor.
❽
Auto iris lens selection switch:
Please change the mode to DC or VIDEO depending on
the type of auto iris lens being used.
❾
Setting button
:
• SETUP button
:
Displays the menu on the screen and uses enter sub menu.
• Up&Down button : Used to move the cursor up or down in the menu screen.
• Left&Right button :
Used to move the cursor left or right in the menu screen.
❿
Power input terminal:
Connects to the power appropriate to each model.
⓫
Power lamp:
Lights up when the correct power is supplied to the camera.
LENS
Lenses are sold separately. Lenses such as an auto iris lens, CS-Mount lens and C-Mount
lens can be used.
• Please keep the lens clean.
• Any foreign objects and fingermarks on the lens can cause inferior image quality in low
light level conditions.
Notes
Rear View
When using an auto iris lens
Installation
1. Please peel off about 8mm of the outer
skin of the auto iris lens cable.
2. Please peel off about 2mm of the outer skin of
the insulated conductor inside the lens cable.
approx. 8mm
approx. 2mm
3. Please remove the cover of the auto iris lens connection plug and solder the lens cable to
the connector pin in the plug.
4. Please replace the auto iris lens connection plug cover and take off the CCD protection
cap, and then attach the auto iris lens to the camera by
screwing it in clockwise.
5. Please insert the connection plug that is connected to
the auto iris lens cable into the auto lens connector,
which is located on the side of the camera.
6. Please set the lens selection switch, located on the side of the
camera, to DC or VIDEO depending on the type of auto iris lens
which is being used.
LENS
Pin No.
DC
VIDEO
No.1 Pin
Damping-
Red (power)
No.2 Pin
NC
No.3 Pin
Drive+
White (video signal)
No.4 Pin
Drive-
Black (GND)
No.3 Pin
No.1 Pin
Connector
Lens cable
No.4 Pin
No.2 Pin
