English - 23
SETTING
UP
INSTALLING THE WATER
DISPENSER LINE
A water dispenser is one of the helpful features on
your new Samsung Refrigerator.
To help promote better health, the Samsung water
filter removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20 ~ 125 psi (138 ~ 862 kPa) is
required.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled.
To do this, press the water dispenser lever until
water runs from the water dispenser.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water supply kit
that contains copper tubing.
Connecting to the water supply line
1. First, shut off the main water supply line and
turn the ice-maker off.
2. Locate the nearest cold water drinking water
line.
3. Install the pipe clamp and shut off valve.
4. Connect the water line installation kit to the
shut off valve.
Shut off valve
Pipe clamp
Cold water line
Water line installation kit
Connecting the water supply line to the
refrigerator
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing
Use Plastic Tubing
•
6.35 mm copper tubing
•
6.35 mm compression
nut (1pc)
•
Ferrule (2pc)
•
6.35 mm plastic tubing
→
Molded end (Bulb)
•
6.35 mm compression
nut (1pc)
Compression
Nut (6.35 mm)
(Assembled)
Ferrule
(Not supplied)
Plastic Tubing
(Supplied)
Compression Fitting
(Assembled)
Bulb (B)
Compression
nut (B) (6.35 mm)
(Not supplied)
or
Copper tubing
(Not supplied)
Plastic tubing (B)
(Not supplied)
Household water line
Refrigerator
1. Connect the household water line to the
assembled compression fitting.
- If you are using copper tubing, slip the
compression nut (
B
) (not supplied) and
ferrule (not supplied) on the copper tubing (not
supplied) as shown.
- If you are using plastic tubing (
B
), insert the
molded end (Bulb) of the plastic tubing (
B
) into
the compression fitting.
Do not use plastic tubing (
B
) without the
molded end (Bulb).
CAUTION
DA68-02981C-00.indb 23
2014. 1. 28. �� 10:47
