Samsung QL 6100, User Manual

Page: 64 / 106

4.
9
Printing
CONFIG
Use this tab to control the following printer features:
•
Power Save
determines the length of time the printer waits after a job
is printed before it goes to a reduced power state. If the printer is used
frequently, select
OFF
which keeps the printer ready to print with the
minimum warm-up time. This uses more electricity to keep the printer
warm and ready to print.
•
Econo Mode
determines the toner quantity the printer should use
when printing. If set to
ON
, the printer conserves toner when printing.
The default value is
OFF
, which provides 100% usage.
•
Auto Continue
determines what action the printer should take when a
manual feed print job is sent to the printer and there is no paper in the
MP Tray. If set to
ON
, the printer will pick up the paper from cassette
after fifteen seconds. Otherwise, the printer will wait for you to load
paper in the MP Tray.
•
Jam Recovery
determines what action the printer should take when a
paper jam occurs. When set to
OFF
, the printer does not reprint a page
that has jammed. When set to
ON
, the printer keeps the image in
memory for a printed page until the printer signals that the page has
successfully printed. The printer reprints all jammed pages.
•
Altitude
helps the printer optimize its output depending on the air
pressure of the region. If you are close to sea level, it should be set to
“Low.” If at a high elevation (1,500 m / 5,000 ft or higher), set it to
“High.”
JOB
Use this tab to control the following printer features:
•
Timeout
determines the amount of time (in seconds) the printer will
wait before printing the last page of a print job that does not end with a
command to print the page or a formfeed character. Valid range is
0
to
300 seconds
.
•
Paper Type
provides the printer with information about the type of
paper to be used for a print job. If you use paper with a weight of more
than 42 lb. (90 g/m
2
), or an envelope, set this to
Thick
and use the MP
Tray’s manual feed slot. Otherwise use the
Normal
setting.
•
Toner Density
determines the overall density of the printed image.
Valid selections are
Light
,
Medium
and
Dark
.
•
Image Quality
mode makes the printer optimize the print quality to
1200 dpi image quality.