Samsung OfficeServ 7000 Series, System Administration Manual

Page: 18 / 46

10
SYSTEM ADMINISTRATOR
PROGRAMMING
CUSTOMER LEVEL ACCESS
Before any customer programs can be accessed, you must first open system pro-
gramming using the passcode you have been assigned. You must use a display
keyset. Should it become necessary to change this passcode, see your service com-
pany.
• While on-hook, press TRSF and then dial 200 .
Your display shows [ENABLE CUS. PROG. PASSCODE].
• Dial the four digit passcode.
The display shows [ENABLE CUS. PROG. - DISABLE].
• Dial 1 to enable. The display shows [ENABLE CUS. PROG - ENABLE].
• Press TRSF . The keyset returns to its idle condition.
• Press TRSF and then dial the three digit program code you want to access.
Follow the instructions for that program.
NOTE: You must begin programming within 30 seconds. Once you are in program-
ming, any delay of more than 30 seconds between key strokes will cause the sys-
tem to automatically close programming.
CUSTOMER LEVEL ACCESS USING THE
PROG KEY
A designated keyset may be programmed with a “ PROG ” key which allows access
to the following areas of system programming.When pressed you must enter your
station passcode followed by the MMC number. The default station passcode
“1234” can not be used. The only MMCs that may entered from pressing the
“
PROG ” key are as follows:
• MMC 100 Station Lock for All Stations
• MMC 102 Station Forward for All Stations
• MMC 104 Station Name
• MMC 115 Program Message for all Stations
• MMC 116 Alarm and Message
• MMC 505 System Day and Time
• MMC 705 System Speed Dial
• MMC 706 System Speed Dial Name
• MMC 722 Station Key Programming
System_Administration_Guide.qxp 4/30/2007 12:56 PM Page 17