Samsung NZ84T9747UK, Installation Instruction Manual

Page: 62 / 383

62
Reset filter saturation
After carrying out maintenance on the filters (grease and/or
activated carbon) hold down the
“ ”
(7) key;
the
“ ”
LED turns off and the count restarts.
Activation of activated carbon odour filter saturation
indicator
This indicator is normally deactivated.
To activate it, proceed as follows:
• turn on the aspiration hob by pressing (1) ;
with the aspiration motor and cooking zones off, press and
hold
“ ”
(7) ;
•
“ ”
turns on, then off to indicate successful activation.
Deactivation of activated carbon odour filter saturation
indicator
repeat the activation steps described above
“ ”
flashes, then turns off to indicate successful
deactivation.
Automatic mode
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the maximum cooking level used in the
cooking zone.
Once the hob is turned off, the hood adapts its aspiration
speed, gradually decreasing it, so as to eliminate residual
vapours and odours
To activate this function:
Briefly press
“ ”
(7) , the LED
“ ”
(D) will light up
to indicate that the hood is working in this mode.
The device can also be used in combination with a
Window sensor KIT (not supplied by the manufacturer).
If the Window sensor KIT is installed (only in the case of use
in EXTRACTOR mode), air extraction will stop working each
time the window in the room, on which the KIT is applied, is
closed.
-The KIT must be electrically connected to the device by
qualified and specialised technical personnel.
-The KIT must be separately certified in accordance with
the safety standards relative to the component and its
use with the device. Installation must be carried out in
accordance with current regulations for domestic
systems.
CAUTION:
-the wiring of the KIT to be connected to the device must
be part of a certified safety extra low voltage (SELV)
circuit.
-the manufacturer of this device declines all liability for
any inconveniences, damage, fires caused by defects
and/or problems associated with malfunction and/or
incorrect installation of the KIT.