Adjustment
8-12
Copyrightⓒ since 1995 Samsung Electronics. All rights reserved.
1. If the camera is not set region after replacing the Main PCB and is purchased from overseas, there are some issues as below.
1) User does not use SNS service country-specific.
2) Do not support multiple languages for display and input when using Wi-Fi.
3) Wi-Fi telecommunication speed may be down.
2. Follow the below steps to set up country. (Page 8-16,Refer to <Table. 8-3>)
1) Open “nx300_Country.adj” and change the country code.
EX> sys_param shipment_country set
055
(
korea code : 055
)
2) Copy the script file to SD card and insert the SD card into the camera.
3) When turning on the camera, the process will proceed automatically.
1. Open “nx300_SN_MAC.adj” and input S/N & Mac Address.
2. Copy the script file to SD card and insert the SD card into the camera.
3. When turning on the camera, the process will proceed automatically (How to check: Menu →Setting → info)
8-9 Country setting (Wi-Fi)
8-10 S/N, Mac address Input
■
It is required to reset up Wi-Fi setting for the specified country after replacing the Main PCB.
■
It is required to input Serial number and Mac Address after replacing the Main PCB.
info.tg
info.tg
nx300_Conutry.adj
nx300_SN_MAC.adj
Fig. 8-21
Fig. 8-20
input Product S/N
input Barcode S/N 12 seat
input MAC Addr.
Firmware information
appliance information
main body Firmware
lens Firmware
MAC address
network number authentication
1.00
01.20
1a:2b:3c:4d:5f:6a
123456789012
