English - 10
installation
Safety instructions for the installation
This oven may be installed only by an approved electrician. The installer is responsible for
connecting the appliance to the main supply, while observing the relevant safety regulations.
•
Ensure protection from live parts when installing the oven.
Power connection
If the appliance is not connected to the mains with a plug, a multi-
pole isolator switch (with at least 3 mm contact spacing) must be
provided in order to satisfy safety regulations. The power cable
(H05 RR-F or H05 VV-F, min., 2.5 mm²) must be of sufficient length
to be connected to the oven, even if the oven stands on the floor in
front of its built-in cabinet. Open the rear connection cover of the
oven with a screwdriver and loosen the screws of the cable clamp
before you connect the power lines to the relevant connection
terminals. The oven is earthed via the ( )-terminal. The yellow and green cable(earth
connection) must be connected first and be longer than the others. If the oven is connected to the
mains with a plug, this plug must remain accessible after the oven is installed. Samsung will take
no responsibility for accidents that originate from a missing or faulty earth connection.
WARNING:
Do not allow the connecting cable to become trapped during installation,
and prevent it coming into contact with hot parts of the oven.
Installation in the cabinet
With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C
inside of the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for
damage of plastic surfaces or adhesive from the heat.
There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed.
For ventilation, a gap of about 50 mm should be left between the lower shelf and the supporting wall.
If the oven is to be installed below a hob, the hob’s installation instructions should be followed.
595
370
560
545
21
595
Max.50
Min.550
Min.560
Min.50
Min.590 ~ Max.600
Min.460 x Min.50
Built-in
572 550
595
370
560
545
21
115
595
175
Max.
464
Min.550
Min.560
Min.600
Min.460 x Min.50
Built-under
Built-in + Built-under
572 550
Max. 476
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws.
Make sure that a gap of at least 5 mm should be left between the appliance and the adjacent cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door
and inside of oven. Before uninstalling the oven from the furniture, disconnect the oven from the
power supply and release the 2 screws on the both sides of the oven.
WARNING:
The built-in furniture must have a minimum ventilation gap for Air-flow
as shown on picture. Do not cover this hole with strips of wood, for this is used to
provide ventilation.
The front exterior of the oven such as handle is different model by model. But the
size of the oven in the picture is same.
BROWN
or BLACK
BLUE or
WHITE
YELLOW
and GREEN
NV66H5737LB_EF_DG68-00533B-02_EN.indd 10
2017-03-29 5:50:20