7
4 . Reassemble the Wi-Fi kit .
• Put the front cover of the kit into the upper grooves first and then fit it as shown in the picture . After
assembling the Wi-Fi kit, please check if there is any gap because of the connection cable between front
cover and rear cover .
• When installing a Wi-Fi kit with 10 m (32 .8 feet) or more wire, the communication wire and power wire of a Wi-Fi kit
should be installed separately . (The Wi-Fi kit will malfunction because of electrical fault . )
• When installing a Wi-Fi kit on the wall, select proper thickness of wires in the consideration of the hole size for wire
on the wall .
• Wire for Wi-Fi kit PCB connection
- When installing a Wi-Fi kit in a buried way, install the kit in accordance with U-terminal wiring Specification .
- When installing a Wi-Fi kit with 4-line PVC wires, peel 30 cm (0 .98 feet) of the sheath for the PVC wire and use only
4-line wires . (Recommnendation: AWG22)
• Specification of compressed U-terminal for connecting Wi-Fi kit PCB
W
t
G
E
F
L
Stud
D
Wire range for
connection
Rated
size
Stud
size
Basic size(mm)
AWG
mm
2
mm
2
mm
t
ΦD
G
E
F
W
L
22~16
0 .25~
1 .65
1 .5
3
0 .7 3 .8 10 .0 4 .5 6 .5 6 .0 21 .2
The maximum wiring length for communication and power : 50 m (164 feet)
• Tighten the fixing screws to the PCB terminal with less than 6Nm torque . When the screws are tightened with more
than 6Nm torque, the screw thread will be damaged .
5 . Start the Wi-Fi kit .
f
f
When the Wi-Fi kit is turned on, all the lamps are turned on until system operates .
f
f
After the system operates, tracking is performed automatically .
6 . Perform the tracking .
❋
❋
Tracking : You can search the devices connected to the Wi-Fi kit with the tracking function . The devices connected to Wi-
Fi kit recognize that they are connected to the Wi-Fi kit . To monitor or control the system air conditioner with
Wi-Fi kit, tracking should be performed .
f
f
When the Wi-Fi kit is turned on, the tracking is performed automatically . During the tracking, the lamp of
the Wi-Fi kit (
) (
) blinks .
f
f
If the tracking is completed but the lamp (
) blinks, it means the Wi-Fi kit does not find connected indoor units . In
this case, check whether the connection of communication cable between indoor unit and outdoor unit is correct or is
affected by noise .
f
f
If the configuration of indoor unit or outdoor unit is changed, tracking should be performed again manually by pressing
the button (SW3) inside the Wi-Fi kit . (
Ⓑ-
)
• Set the OnOff controller of indoor units to 'Use' in the option setting to control indoor units through the Wi-Fi kit . If
the OnOff controller is set to 'Disuse', the indoor units cannot be controlled with the Wi-Fi kit .
• When the tracking is completed correctly, the process which connects the wired/wireless router to the Wi-Fi kit is
required to control indoor units by a mobile phone . For this process, refer to the 'Starting Samsung Smart Home
App' in Page 11 .
• When the tracking is completed correctly, the lamp (
) is turned on until the process which connects the wired/
wireless router to Wi-Fi kit is completed .
NOTE
CAUTION
CAUTION
NOTE
CAC Wifi APP-NA_IBIIM_EN_DB68-05417A-00.indd 7
2015-03-16 오후 2:21:46
