16
Step-by-step installation guide
To use the toggle bolts:
Wall
Toggle Wings
Toggle
Bolt
Bolt End
Spacing for Toggles More
Than Wall Thickness
Mounting
Plate
Bolt End
Mounting
Plate
Toggle
Bolt
Wall
Toggle Wings
3
. Place the mounting plate against the wall, pinch
the wings of each toggle together, and then insert
the toggle wings of each toggle into and through
the holes in the wall.
NOTE
: Before tightening the toggle bolts and wood
screw, make sure the bottom of the Mounting plate
runs along the bottom Horizontal line of the “Rear wall
Template” and the Mounting plate is properly centered
under the cabinet.
CAUTION
: Be careful to avoid pinching your fingers
between the back of the mounting plate and the wall.
4
. Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts. Tighten the screw.
C. USE THE TOP CABINET
TEMPLATE TO PREPARE
THE CABINET ABOVE
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION
: Wear safety goggles when drilling holes in
the cabinet bottom.
D. MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip the handle or use
the handle during installation to support the
microwave.
NOTE
: If your cabinet is metal, use the nylon
grommet in the power cord hole to prevent the cord
from being cut.
NOTE
: Filler blocks are required when mounting this
unit under any cabinet with a recessed bottom or
front overhang. (See page 9.)
IMPORTANT: The case damage that will occur
from over tightening screws if you do not use
filler blocks is not covered under warranty.
IMPORTANT: For models with the grease filter
installed, don’t push up on the filter when you
mount the oven.
NOTE
: When mounting the microwave oven, thread
the power cord through hole in the bottom of the top
cabinet. Keep it tight throughout Steps 1–3. Do not
Grease Filter
Grease Filter
ME21K6000AS_AA_DE68-04108C-00_EN.indd 16
5/20/2016 5:06:34 PM
Summary of Contents for ME21K6000A
Page 19: ...19 Notes ME21K6000AS_AA_DE68 04108C 00_EN indd 19 5 20 2016 5 06 34 PM ...
Page 20: ...DE68 04108C 00 ME21K6000AS_AA_DE68 04108C 00_EN indd 20 5 20 2016 5 06 34 PM ...
Page 39: ...19 Notas ME21K6000AS_AA_DE68 04108C 00_MES indd 19 5 20 2016 5 06 50 PM ...
Page 40: ...DE68 04108C 00 ME21K6000AS_AA_DE68 04108C 00_MES indd 20 5 20 2016 5 06 50 PM ...