GB
13
12
You can view the various functions available on your system.
Press the
Demo
button.
Result: The various functions available are listed in turn on the
display.
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate
sections.
To cancel this function, press
Demo
again.
Your system is equipped with a clock which allows you to
turn your system on and off automatically. You should set
the clock:
When you purchase the mini-compact system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing
On/Standby
.
Press
Timer/Clock
twice.
Result:
CLOCK
is displayed.
Press
Enter
.
Result: The hour flashes.
To...
Turn the Multi Jog knob to the...
Increase the hours
Right
Decrease the hours
Left
When the correct hour is displayed, press
Enter
.
Result: The minutes flash.
To...
Turn the Multi Jog knob to the...
Increase the minutes
Right
Decrease the minutes
Left
When the correct time is displayed, press
Enter
.
Result: The clock starts and is displayed, even when the system is
in standby mode.
You can display the time, even when you are using another
function, by pressing
Timer/Clock
once.
You can also use
/
buttons to instead
Multi Jog
knob in step 4,6.
Setting the Clock
Viewing the Various Functions on
Your System
2
1
1
2
3
4
5
6
7
2
1
4,6
3,5,7
4,6
4,6
B
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The
AM
aerial connector terminals are located on the rear of the system and are
marked
AM
.
To avoid noise interference, check that the loudspeaker wires do not run
close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
Connecting the AM (MW)/LW Aerial
How to connect a COAXIAL TYPE aerial.
Connect a 75
Ω
antenna to the
FM
antenna terminal.
Plug the connector on the
FM
aerial supplied into the coaxial socket (75
Ω
) marked
FM
on the rear of the system.
Follow the instructions given on
Page 23
to tune into a radio station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor
FM
aerial to the
FM
socket on the rear of the system using a 75
Ω
coaxial cable (not supplied).
Connecting the FM Aerial
DIGITAL OUT
OPTICAL
DIGITAL OUT
OPTICAL
DIGITAL OUT
OPTICAL
NTSC/PAL Selection Method
According to a DISC or TV, Press the REC/Pause button on the front
panel.
Set the system to standby(power off) mode, press the
REC/Pause
button
on the front panel.
Result: Each time the
REC/Pause
button is pressed, the following appears
in the display:
NTSC PAL
*
This function can be operated only from the main unit.
