Installing the Washing Machine
4
SAMSUNG
Washing Machine Owner
’
s Instructions
Installing
Plugging in the ma
For European Users.
Yo
For U.S. Users.
You
MUS
Check with a licensed electrici
grounded.
For U.K. Users.
Wiring lnstructions
WARNING THIS APPLIANCE
This appliance must be earthed
electrical short circuit, earthing
shock providing an escape wir
The appliance is equipped wit
includes an earth wire for conn
of your mains plug.
The plug must be plugged into
installed and earthed.
*The wires in this mains lead a
with the following code:
•
Green and yellow
•
Blue
•
Brown
•
AS the colours of the wires i
appliance may not correspo
markings indentifying the t
proceed as follows.
•
Connect the green and yello
in the plug marked with the
symbol (
) or coloured g
yellow.
•
Connect the blue wire to the
with the letter N or coloured
•
Connect the brown wire to t
with the letter L or coloured
* Consult a qualified electricia
if in doubt about any of thes
The manufacturer of this wa
not accept any liability for d
material for non observance
There are no
user serviceabl
washing machine and if the
appliance is damaged, it mu
qualified service personnel a
manufacturer because spec
Connecting the water supply hose
The water supply hose must be connected to the washing machine at one end and to the
water faucet at the other. Do not stretch the water supply hose. If the hose is too short and
you do not wish to move the water faucet, replace the hose with a longer, high pressure
hose.
To connect the water supply hose:
1.
Take the L-shaped arm fitting for the cold
water supply hose and connect to the cold
water supply intake on the back of the
machine. Tighten by hand.
2.
Connect the other end of the cold water supply hose to your sink's cold water faucet and
tighten it by hand. If necessary, you can reposition the water supply hose at the washing
machine end by loosening the fitting, rotating the hose, and retightening the fitting.
Option: 1.
Take the red L-shaped arm fitting for the hot water supply hose and
connect to the red hot water supply intake on the back of the machine.
Tighten by hand.
2. Connect the other end of the hot water supply hose to your sink's hot
water faucet and tighten it by hand.
3. Use a Y-piece if you only want to use cold water.
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a sink
The drain hose must be placed at a height of
between 60 and 90 cm. To keep the drain hose
spout bent, use the supplied plastic hose
guide. Secure the guide to the wall with a
hook or to the faucet with a piece of string to
prevent the drain hose from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least
60 cm above the ground.
ln a drain pipe
Samsung recommends
that
you use a 65 cm high vertical pipe; it must be no shorter than 60
cm and no longer than 90 cm.
