Samsung LED 8000 series, User Manual

Page: 36 / 609

English - 36
Configuring Network Connections
After you have run the initial setup, you can configure or reconfigure the network connections through the
TV's menu.
Configuring a Wireless Network Connection
The instructions below are for networks that use the Dynamic Host Configuration Protocol (DHCP) to
configure network connections automatically. Most wireless networks use DHCP. If you have a Static IP
network, see the e-Manual for configuration instructions.
To configure the network connection for a network that uses DHCP, follow these steps:
1. Connect your TV to your network as shown in the illustration on page 34.
2. Turn on your TV, and then go to the Network Settings screen. ( Menu
ĺ
Network
ĺ
Network
Settings )
3. Select Start . The Network function searches for available wireless networks. When done, it displays a
list of the available networks.
4. In the list of networks, move the highlight to select a network, and then select Next .
✎
If you have a WPS(PBC) compatible router, select WPS(PBC) instead, and then follow the
directions on the screen.
5. Enter your network security key or WPS PIN using your remote.
✎
Enter numbers and letters using your remote.
Ř If you are using the standard remote, you can enter numbers by pressing the number buttons
on your remote.
Ř To enter a letter, move the Highlight to the letter, and then select it. You can enter numbers in
the same fashion if you choose.
✎
To display capital letters (or redisplay small letters if capital letters are displayed), select Caps or
Shift .
✎
To display symbols and punctuation, select
F
. To redisplay letters, select
F
again.
6. When done, select Next if you have entered a security key or WPS PIN if you have entered a WPS PIN.
7. The TV checks the wireless connection. If the connection is successful, the “ You are connected to the
Internet. If you have any problems using online services, please contact your Internet Service
Provider.
” message appears. Select Next using your remote.
✎
For more detailed information, see “Setting up the Wireless Network” in the e-Manual.
✎
If you want to configure the connection manually, select IP Settings on the Network Connection
screen. Set IP Mode to Manual , and then enter the IP Address , Subnet Mask , Gateway , and
DNS Server manually.