3-12
Chapter 3
Installing Printed Circuit Cards
MISC BOARD
This board has no selectable options and installs in position LOC3 of the MCP card when the system
has one cabinet installed
(see Figure 3-1)
. If the system has more than one cabinet the MISC board
must be installed in position LOC2 of the SCP card
(see Figure 3-3)
or position LOC2 of the LCP cards.
Up to 3 MISC boards can be installed in a system (one on the MCP or SCP and one on each LCP).
The MISC board is required to provide external music inputs, external page outputs and
programmable relay contacts. To install the MISC board remove the two (2) screws holding the MCP
or LCP protective casing together
(see Figure 3-6)
or remove the 4 screws holding the SCP case together
(see Figure 3-10)
and separate the two halves of the case. Place the MISC board face down over the two
connectors, taking care to properly line them up and press gently on the back of the board to seat it.
The MCP/LCP/SCP case can now be reassembled if all required daughter boards have been installed.
Figure 3-9
MISC Board
Figure 3-10
Processor Card Screw Location
