ENG
17
16
CONNECTIONS
INSTALLATION
DETACHIng THE SOUnDBAR FROM THE WALL
1.
To separate the Soundbar from the wall mount, push it in the direction of arrow, tilt it up slightly, and then pull it
away from the wall as shown.
●
Do not hang onto the installed unit and avoid striking or dropping the unit.
●
Secure the unit firmly to the wall so that it does not fall off. If the unit falls off, it may cause an injury or
damage the product.
●
When the unit is installed on a wall, please make sure that children do not pull any of the connecting
cables, as this may cause it to fall.
●
For the optimal performance of a wall mount installation, install the speaker system at least 5 cm below the
TV, if the TV is mounted on the wall.
●
For your safety, if you do not mount the unit on the wall, install it on a secure, flat surface where it is unlikely
to fall.
●
Do not connect the power cord of this product or your TV to a wall outlet until all connections between
components are complete.
●
Before moving or installing this product, be sure to turn off the power and disconnect the power cord.
CONNeCTING THe SuBWOOFer
COnnECTIng TO THE SUBWOOFER AUTOMATICALLy
The Subwoofer's linking ID is preset at the factory and the main unit and subwoofer should link (connect wirelessly)
automatically when the main unit and subwoofer are turned on.
•
When the subwoofer is completely connected, the blue LeD Link Indicator on the subwoofer stops blinking and
glows continuously.
COnnECTIng TO THE SUBWOOFER MAnUALLy
If the blue LeD light does not stop blinking when the main unit and subwoofer are turned on, please set the ID by
following the steps below.
●
Important: Before you begin, put the battery into the remote. See page 11 for instructions.
1.
Plug the power cords of the main unit and subwoofer into an AC wall outlet.
2.
Press the
ID SET
button on the rear of the subwoofer with a small, pointed object for 5 seconds.
•
The STANDBY indicator turns off and the LINK indicator (Blue LeD) blinks quickly.
3.
While the main unit is powered off (in STANDBY mode), press and hold the (Mute) on the remote control for
5 seconds.
4.
The
ID SET
message appears on the Soundbar's display.
5.
To finalize the link, turn the main unit’s power on while the subwoofer’s Blue LeD blinks.
•
The main unit and the subwoofer should now be linked (connected).
•
The LINK indicator (Blue LeD) on the subwoofer should be glowing continuously and not blinking.
•
If the LINK indicator is not solid blue, the linking process has failed. Turn off the main unit and start again from
Step 2.
•
You can enjoy better sound from the wireless subwoofer by selecting a Sound effect. (See page 9)
CONNeCTIONS
