English
17
02
Connections
Installing the Speakers on the Tallboy Stand
* Surround Speakers
1.
Turn the Stand Base upside-down and connect it to the Stand.
2.
Insert three screws (5*15, For connecting Stand & Stand Base)
clockwise into the three holes marked using a screwdriver as shown in
the illustration.
!
CAUTION :
When you use a torque screwdriver, be careful not to
put excessive force. Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm)
3.
Straighten a supplied speaker wire and put in the hole on the centre of
Stand Base.
4.
Connect the upper Speaker to the assembled Stand.
5.
Insert another large screw (5*15, For connecting Speaker & Stand)
clockwise into the hole on the rear of the speaker using a
screwdriver.
6.
This is the appearance after the speaker is installed. Follow this
steps to install other speaker.
Installing the Speakers on the Half Tallboy Stand
* Front Speakers(Method 2)
1.
Connect the speakers with the partition-stand as shown.
2.
Insert two screws (5*15, For connecting Speakers & Partition-
Stand) clockwise into the hole marked using a screwdriver as
shown in the illustration.
!
CAUTION :
When you use a torque screwdriver, be
careful not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver- below 15
kg.f.cm
)
.
3.
This is the appearance after the speaker is installed.
1
nections
2
3
5
3
2
6
1
4
Stand Base
Stand
Speaker
Stand
