10
Description of the Appliance
1. Top Plate
2. Auxiliary Burner
3. Semi-rapid Burner
4. Rapid Burner
5. Triple crown Burner
6. Control handle for left burner
(Tpiple crown burner or Rapid burner)
7. Control handle for center
front burner
(Semi-rapid burner)
8. Control handle for center
rear burner
(Auxiliary burner)
9. Control handle for right
burner (Semi-rapid burner)
10. Castiron left pan support
(for Triple crown burner)
11. Castiron left pan support
(for Rapid burner)
12. Castiron middle pan support
13. Castiron right pan support
14. Drawing left pan support
(for Triple crown burner)
15. Drawing left pan support
(for Rapid burner)
16. Drawing middle pan
support
17. Drawing right pan support
18. Wok pan support
Handle
19-1
19-2
20
21
22
23
19
Triple crown
Auxiliary, Semi-rapid and Rapid
19. Burner lid
19-1. Inner Burner lid
19-2. Outer Burner lid
20. Flame Spreader
21. Burner Cup
22. Ignition Electrode
23. Flame supervision device
24
25
Wok pan support
24. Wok pan
support
25. Pan support
26
27
28
26. Control handle
27. Sealing ring
28. Tap
Burner
18
10 2
12
13
5
6
7
8
9
1
3
11 2
12
13
4
6
7
8
9
1
3
14 2
16
17
5
6
7
8
9
1
3
15 2
16
17
4
6
7
8
9
1
3
11
Turn on
Preparation
1
The following symbols will appear on the control panel, next to each control handle :
Ignition & Adjustment
2
■ Open the middle valve.
■ Place a pot or a pan on the corresponding cooking position.
■ Fully press down the control handle for the corresponding cooking position and turn it to the
left, to the ignition position, and hold it there for a few seconds at most until the burner ignites.
■ After igniting, keep the control handle pressed for about 5~8seconds more because the heat
sensor that opens the gas channel has to warm up first. And set control handle to the position you
want.
■ If the burner does not light, repeat the process.
■ The flame size can be set continuously between maximum and minimum by slowing turning the
control handle.
How to Use
■ The minimum setting is at the end of the anti-clockwise rotation of the control handle.
■ All operation positions must be selected between the maximum and minimum position.
■ The symbol on the control panel, next to the control handle will indicate which burner it operates.
■ If the igniters are dirty, this makes the burner harder to light, so you
should keep them as clean as possible. Do this with a small brush and
make sure that the ignition device is not hit or knocked violently.
■ The flame supervision device shall not be operated for more than 15s. If
after 15s the burner has not lit, stop operating the device and open the
compartment door and/or wait at least 1min before attempting a further
ignition of the burner.
Circle : gas off
Large flame : maximum setting
Small flame : minimum setting
Ignition position
