22
Cut out size
Width : 560mm
Depth : 480mm
Thickness : 30~50mm
■ This appliance is to be built into a kitchen unit or 600mm worktop, providing the
following minimum distances are allowed ;
- The edge of the appliance must be a minimum distance of 55mm from a rear wall.
- A minimum distance of 100mm must be left between the side edges of the appliance and any
adjacent cabinets or walls.
- The minimum distance combustible material can be fitted above the appliance in line with the
edges of the appliance is 400mm. If it is fitted below 400mm a space of 50mm must be allowed
from the edges of the appliance.
- The minimum distance combustible material can be fitted directly above the appliance is 700mm.
- This panel(a) must be positioned at a maximum distance of 150mm below the worktop.
400 mm
560
mm
480
mm
400 mm
700 mm
55
mm
100 mm
FO 0812
CLEARANCES REQUIRED
WHEN FITTING THE HOB
WITHOUT A COOKER HOOD ABOVE
FO 0813
400 mm
560
mm
480
mm
400 mm
700 mm
600 mm
55
mm
100 mm
CLEARANCES REQUIRED
WHEN FITTING THE HOB
WITH A COOKER HOOD ABOVE
Positioning
40mm
150mm (MAX)
a
23
1. Remove the pan support, the burner lid and
flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices and flame
supervision devices are not damaged in this
operation.
2. Apply the sealing strip provided around the
edge of the appliance.
3. Do not leave a gap in the sealing agent or
overlap the thickness.
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
1. Place the bracket(B) over the holes that match the size
of the screws.There are one set of screw holes in each
corner of the hob(H).
Slightly tighten a screw(C) through the bracket(B) so
that the bracket is attached to the hob, but so that you
can still adjust the position it.
2. Carefully turn the hob back over and then gently lower it
into the aperture hole that you have cut out.
3. On the underneath of the hob, adjust the brackets into a
position that is suitable for your worktop.
Then fully tighten the screws(C) to secure the hob into
position.
Installing the Appliance
(A) SEALING STRIP
(B) BRACKET
(C) SCREW
H
H
H
H
H
H
H
H
