English - 32
PROBLEM
POSSIBLE CAUSE
SOLUTION
Has food particles
remaining on the
dishes.
An inappropriate programme
was been selected.
Select a programme according to the soil level
of the dishes as directed in this manual.
The fi lter is contaminated or not
correctly fasten.
Clean the fi lter and make sure the fi lters are
fi tted properly.
No dishwasher detergent or not
enough detergent is being used.
Use an automatic dishwasher detergent or
use more detergent.
The pressure of the supplied
water is low.
The water supply pressure must be between
0.05 MPa and 0.8 MPa.
Spray arm jets are clogged.
Clean the spray arms.
The dishes are improperly
loaded.
Rearrange the dishes so they have good
water access and do not interfere with spray
arm and dispenser operation.
The water is too hard.
Check salt refi ll indicator and refi ll dishwasher
salt.
Does not dry dishes
well.
There is no rinse aid in the
dispenser or not enough rinse
aid was used.
Check the dispenser and add rinse aid.
Check rinse aid setting.
Multi taps were used without
selecting the
Dry+
function.
Select the
Dry+
function or use rinse aid.
Glasses and cups with concave
bottoms hold water. This water
may spill onto other items when
you are unloading.
After fi nishing the cycle, empty the lower rack
fi rst and then the upper, this will avoid water
dripping from the upper rack onto the dishes
in the lower rack.
Is too noisy.
The dishwasher beeps when the
dispenser cover is opened and
during the initial stage of draining
the pump operation.
This is a normal operation.
The dishwasher is not level.
Ensure that the dishwasher is level.
There is a ‘chopping’ sound
because an arm is bumping
against the dishes.
Rearrange the dishes.
Leaves a yellow or
brown fi lm on cups or
dishes
This can occurs from coff ee and
tea soils.
Use programme with higher temperature.
Does not have any
indicators lit.
The power cord is not
connected.
Connect the power cord.
Does not have
smoothly rotating
arms.
The arms are clogged with food
particles.
Clean the arms.
Leaves a white
coating on cutlery
or crockery after
cleaning.
Hard water was used.
Check the salt fi ll indicator and softener
setting is correct according to the water
hardness of your area.
Check salt reservoir cap is correctly fi tted.
Troubleshooting and
information codes
BU_DW9000H-00156A-07_EN.indd 32
BU_DW9000H-00156A-07_EN.indd 32
2016-09-20 12:31:46
2016-09-20 12:31:46
