Before using for the first time
_13
02 Be
FOR
e
USI
n
G
using the sound on/off function
1.
While holding down the
delay start
and
half load
buttons, press the
power
button to
access the setting to activate/deactivate the
Sound On/Off
function.
2.
Press the
sanitize
button to activate or deactivate the
Sound On/Off
function.
-
“Rinse Refill ”
indicator turns on to indicate that
Sound On
function has been activated.
-
“Rinse Refill ”
indicator turns off to indicate that
Sound Off
function has been activated.
Even though
Sound Off
function has been activated, the error sound plays when an error occurs.
3.
To exit the
Sound On/Off
setting, press the
power
button.
using dishWasher salt
Filling the salt reservoir
In order to use soft water, you need to fill the salt reservoir with dishwasher salt.
Use dishwasher salt only.
Do not use any other type of salt or solvent. This may damage the salt reservoir and the water
softening system.
1.
Open the door.
2.
Open the salt reservoir cap by rotating it counterclockwise.
3.
Fill the salt reservoir with water(only required when switching on the
appliance for the first time)
4.
Add the dishwasher salt.
The salt reservoir’s capacity is about 1 kg. Do not overfill the salt
reservoir.
5.
Remove excess salt from around the salt reservoir opening and cap
seal.
If the excess salt is not removed, the salt reservoir cap may not
close properly and allow salt water flow out with negative impact
to the performance.
6.
Rotate the salt reservoir cap clockwise until it is completely shut.
If you are not planning on washing dishes right away, run the
Prewash
to clean the cabinet of excess salt.
Depending on the size of the salt grains, it may take a while for
the salt to dissolve and the
“Salt Refill ”
indicator to turn off.
CAUTION
CAUTION
CAUTION
DD68-00092A_EN.indd 13
10/14/2011 3:08:55 PM
