Samsung DVD-V5600, Service Manual

Page: 212 / 252

Circuit Operating Descriptions
13-46
Samsung Electronics
Vref
Vref
Vref
Pin13 of U1 (FOD)
Pin40 of RIC1 FEI
Pin38 RIC1 SBAD
(3) Operation
1) FOCUSING SERVO
(a) Focus Input
The focus loop is changed from open loop to closed loop, and the triangular waveform moves the object lens up
and down (at pin 172 of U1 during Focus SERVO ON.) At that time, S curve is input to pin 142 of U1.
SBAD (pin 38 of RIC1) signal, summing signal of PD A, B, C, D, is generated, and zero cross(1.5V) point occurs when
S curve is focused and SBAD signal exceeds a preset,constant value. The focus loop is changed to
closed loop, and the object lens follows the disc movement, maintaining a constant distance from the disc.
(these operations are same in CD and DVD).
Fig. 13-43
(b) Play
When focus loop closes the loop during focus servo on, pin 142 of U1 are controlled by VREF
voltage (approx. 1.5V), and pin 40 of RIC1 are approximately 1.5V.
2) TRACKING SERVO
A. NORMAL PLAY MODE
Œ
For DVD
Composite : The signal output from PD A, B, C, D of Pick-up, the tracking error signal (pin39 of RIC1) uses the
phase difference of A+C and B+D in RIC1, and inputs to terminal 139 of U1. Pin 139 of U1 is controlled
by VREF(approx. 1.5V) during normal play.
Meanwhile, DVD repeats the track jump from 1 to 4 in inner direction at normal play (because data- read speed
from disc is faster than data output speed on screen).
´
For CD, VCD
Receive the signal output through E, F of Pick-up, from RIC1. The tracking error signal is similar to DVD.