Samsung DVD-V5600, Service Manual

Page: 220 / 252

Reference Information
14-2 Samsung Electronics
14-3 Main Mechanism and Functions
14-3-1 Tape Path System
The tape come out from the supply reel (S) of the video cassette runs through paths shown in Figs. 14-2 and 14-3,
and is taken up by the take-up (T) reel. (S stands for the supply reel, and T for the take-up reel, hereafter.)
At S reel side (tape enterance side of the cylinder) against the cylinder, a tension post to allow the tape surface to
contact with each head with a proper tension which assures stable running, an FE head which erases entire data
of the tape, and an S guide roller which restricts tape motion in upward/downward direction are provided.
In the same way, a T guide roller, audio head to record audio signals at upper side of the tape, control head to
record and reproduce a control signal at lower side of the tape, and an audio erase head to erase only the audio
signals and perform after-recording in parallel with the audio head are provided at T reel side. (tape exit side of
the cylinder).
The guide parts marked with asterisks (*) are equipped with the adjusting mechanism to stabilize the tape run-
ning or to record and reproduce the signals precisely.
Fig. 14-2 Tape Path System
S guide roller T guide roller
Tilt
Azimuth
S slant guide
FE head
RPS
(released by
FF/REW mode)
Tension lever
& tension post
Cylinder
ACE adjusting screw
T slant guide
ACE head base
Pinch roller
Capstan motor
No.9 guide
(pulled out at
RPS model)
No.8 guide
ACE head position
adjusting screw
ACE head position adjusting slite
Height
Fig. 14-3 Guide Path System
Tension post
S slant guide
Cylinder
FE head
S guide roller
ACE head
T guide roller
T slant guide
Capstan
No.9 guide
Pinch roller
No.8 guide
show the locations to be adjusted.
*
*
*
*