Samsung DJ68-00450F, User Manual

Page: 12 / 32

memo _13 12_ Troubleshooting
pRObLEM possible solution
Vacuum cleaner won’t run
• Power cord not plugged in
• Blown fuse/tripped breaker in home • Check electrical plug
• Check/ Replace fuse or reset breaker
Vacuum cleaner and tools won’t pick up dirt
• Incorrect Height Adjustment
• Hose not attached to suction opening
• Twist Snap Hose not securely attached
• Crack or hole in Hose
• Broken or worn Drive Belt
• Rotating Floor Brush bristles worn
• Rotating Floor Brush jammed
• Clog in vacuum
• Dust Bin full
• Dust Bin not installed properly
• Filters are dirty
• Mini Turbo Brush is clogged or debris is
wrapped around the brush roll
• Adjust Powerfoot to correct height setting
• Firmly push Hose Wand onto the suction
opening
• Make sure Twist Snap Hose is snapped
into locked position.
• Check Hose and replace if needed
• Replace Drive Belt, see pg. 10
• Replace Brush
• Remove brush and clean debris from
brush ends
• Clear clog, see pg. 8-9
• Empty Dust Bin
• Position correctly and lock in place
• Check Pre-motor and Post-motor filters
• Maintaining Mini Turbo Brush, see pg. 11
Visible dirt escaping from cleaner
• Dust Bin full
• Filters missing or installed incorrectly
• Dust Bin installed incorrectly
• Empty Dust Bin
• Check Pre-motor and Post-motor filters
for correct installation
• Pull out and re-attach Dust Bin correctly
Troubleshooting
Check this list of possible problems and solutions before bringing your vacuum to a
service center.