7
I n s t r u c t i o n s : T V P o w e r , V o l u m e , a n d T V I n p u t
113
2.
Enter the search code
. Refer to the table below and use the number keys on your
remote control to enter the appropriate code.
After you press the fourth digit of the code, the red light on the end of the remote
control will flash twice, then remain on.
3.
Test the remote control
. Point the remote control at the TV or A/V stereo system.
Press CHAN UP. Did the TV or A/V stereo system turn off? If not, wait two or three
seconds, then press CHAN UP again. Continue doing this until the TV or A/V stereo
system responds.
When the TV or A/V receiver does turn off, press ENTER to select the current code.
The red light at the end of the remote control will flash three times to indicate that the
remote control is properly coded to control your device.
When the red light on the end of the remote control turns off, you have reached the end
of the available codes.
Unfortunately, due to the great variety of TVs and A/V stereo systems, some makes
and models are not compatible with your DVR’s remote control. If you reach the end
of the available codes without finding a code that works with your device, you will
need to use your TV or A/V stereo system’s remote to turn it on and off, and control
the volume.
To Test:
TV power, volume,
and muting
TV input
A/V system power,
volume, and mute
A/V system volume
and mute only
Enter:
0999
0999
1999
1999
Users_Guide_DTV3.1.book Page 113 Wednesday, June 4, 2003 7:08 PM
