Installation
Duct
Connecting the power and
communication cables
CAUTION
• Always remember to connect the refrigerant pipes before
performing the electric connections. When disconnecting
the system, always disconnect the electric cables before
disconnecting the refrigerant pipes.
CAUTION
• Always remember to connect the air conditioner to the grounding
system before performing the electric connections. Use a crimp ring
terminal at the end of each wire.
The indoor unit is powered through the outdoor unit by means
ͱ˙ɇ²ߚߟŵĘࣞʀͱ͝͝ʪʀϩ̈ͱ͝ʀɇɵ̷ʪࣔͱθɇ͔ͱθʪΧͱиʪθ͔ͱʒʪ̷ࣕࡨӥϩ˵
insulation in synthetic rubber and a jacket in polychloroprene
ࣔ͝ʪͱΧθʪ͝ʪࣕࡨ̈͝ɇʀʀͱθʒɇ͝ʀʪӥϩ˵ϩ˵ʪθʪαЇ̈θʪ͔ʪ͝ϩϑϑΧʪʀ̈˙̈ʪʒ̈͝ϩ˵ʪ
standard EN 60335-2-40.
1
Remove the screw on the electrical component box and remove
the cover plate.
2
Route the connection cord through the side of the indoor unit
and connect the cable to the terminals refer to the figure below.
3
Route the other end of the cable to the outdoor unit through the
ʀʪ̷̈̈͝˝ইϩ˵ʪ˵ͱ̷ʪͱ͝ϩ˵ʪиɇ̷̷
4
Reassemble the electrical component box cover, carefully
tightening the screw.
AC***BNHDCH
1(L) 2(N) L
N
F1
F2
Cable
Main power
L N
F1 F2
cable
Communication
cable
Indoor Power cable
Cable clamp
tie
Indoor Unit
Outdoor Unit
Cable clamp
NOTE
• Terminal Block of the outdoor unit may be different from the
diagram depending on the model. Refer to the manual of the
outdoor unit for the configuration of the terminal block of the
outdoor unit.
Indoor power supply
Power supply
Max/Min(V)
Indoor power cable
208 to 230V, 60 Hz
±10%
0.0023 inch
2
ॱࣔߛߟ͔͔
2
ॱࣕࡨߝ
wires
Communication cable
ߚߚߚߛߜ̈͝ʀ˵ࠏॱࣔߚߡߟ͔͔
2
ॱࣕࡨߜӥθʪϑ