Samsung Electronics
7-2
Troubleshooting
7-1-4. Zero point and Inclination Adjustment
1. Turn the power on again and set time initial condition to Ò8888Ó.
2. Put a dish inside the cooking space.
3. Press the Power level+defrost keys simultaneously until Ò0000Óis displayed (about 5 seconds).At this
time lamp and the rotating dish motor are on.
4. After 10 seconds, A normal neading is between 3150 and 3650.
5. Put the 1Kg standard weight at the center of the ceramic dish and close the door.
(When setting the 1Kg weight, put the assy rack wire, tray oil, assy shaft barbecue and four shaft
barbecue on the ceramic tray. Then do the zero point adjustement.)
6. Press the Power level+Reheat keys simultaneovsly until the Ò1111Óis displayed.
(about 5 seconds). At this time lamp and the rotating dish motor are on.
7. After 10 seconds, A normal reading is between 0350 and 0650.
8. Press the cancel key to complete the adjustment.
7-1-5. Error codes
Error indication
Cause of occurrence
Management method
Remarks
E0
Gas sensor open/short
Check the connection and
Automatic
(sensor value
cooking reheating
reheating
between 6 and 211)
Put the power switch again and
and use it after 10 minutes.
E1
Exceeds of T1 time limit
First press the cancel key and
Automatic
(gas sensor)
check if the food is positiotes
reheating
E3
Sensor Thermistor Open/Short
Exchange the sensor thermistor
check the wire connection
E4
Problem with the weight
Exchange the weight sensor
sensor (Output frequency=0Hz) Check the wire connection
E6
Excess of maximum allowed
When cooking 300g or less,
time with maximum load
cook within 10minutes.
(When cooking food that
weight less tman 300g the
maximum time is 10 minutes.)
E9
Fire in cavity or
Operate oven after cooling
overheated.
down.
E10
Problen with the EEPROM
Replace the PCB assy
Assy High Rack Wire
Assy Shaft Barbecue
Shaft Barbecue
Tray Oil
