38
How to connect your extended power cables
1. Prepare a compressor and the following tools.
Tools
Crimping pliers
Connection sleeve
(mm)
Insulation tape
Contraction tube (mm)
Spec
MH-14
20xØ6.5(HxOD)
Width 19mm
70xØ8.0(LxOD)
Shape
2. As shown in the figure, peel off the shields from the rubber or wire of the
power cable.
- Peel off 20 mm of the wire shields of the tube installed already.
• After peeling off the tube wire, you must insert a contraction tube.
• For information about the power cable specifications for indoor and
outdoor units, refer to the installation manual.
C
AUTION
(Unit: mm)
120
60
20
20
20
180
Power cable (provided by us)
20
Wire tube power cable
3. Insert both sides of core wire of the power cable into the connection
sleeve.
f
f
Method 1
Push the core wire into the sleeve from both sides.
Connection sleeve
f
f
Method 2
Twist the wire cores together and push it into the sleeve.
Connection sleeve
4. Using a compressor, compress the two points and flip it over and compress another two points in the same
location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to make sure it is firmly pressed.
Compression
dimension
f
f
Method 1
Compress it 4 times.
5 mm
f
f
Method 2
Compress it 4 times.
5 mm
Summary of Contents for AM FNCD Series
Page 40: ......
